| Display: |
Two digit, 4 inch high LED. Red standard; green available. Also available with 1" digits on special order.
|
| Time Range: |
1 to 99 minutes in 1 minute increments |
| Controls: |
Front panel Run/Set toggle. In Set mode, Increment pushbutton is held until desired time is indicated on 2 digit display on control unit. Toggle in Run position enables normal operation. Front panel display reads same as remote display. Two LED's indicate status |
| Display Physical: |
Furnished mounted on 9.40 x 7.10 inch aluminum plate, 1.8" deep. Red 1/8" Plexi cover plate 13.5" x 9.5" included. Mounting holes in plate and Plexglas provide for mounting flexibility. |
| Control Physical: |
1.5" high by 5.5" wide by 9.0" deep. Weight 3 pounds |
| Included Accessories: |
Power supply, 20 foot 4 conductor interconnect cable
|
| Accuracy: |
Within 10 seconds per hour. If set for 30 minute interval, deviation from time-of-day approximately 80 seconds at end of 8 hour day |
| Optional Accessories: |
RK-3 Rack Mount Kit; additional display units |
| Warranty: |
Two years parts and labor |
| Operating Modes: |
a) counts down continuously; upon reaching zero reverts to present number and starts counting down again.
b) counts down as long as contact is maintained across start terminals.
c) starts counting upon momentary contact across start terminals.
d) same as (c) but momentary contact while counting will cause display to revert to preset count. |
| Start Input: |
Optoisolated input. Start switch must be capable of switching 12 VDC @ 20 mA. Screw terminals on plugable block |
| Relay Output: |
Three screw terminals on plugable block SPDT relay rated at 2 Amps, 24 VDC. Activates for 1 second |
| Display Connection: |
4 wire; 2 for RS-485 data; 2 for 12 VDC power @700mA |
| Power: |
Supplied 15 VDC 900 mA external power supply. Sufficient for control unit and one display; multiple displays require additional power
|
